Differential Probe for Power management- Model 4233
The 4233 meets EN61010 Category III Requirements. With wide choice of attenuation
ration, the 4233 is capable of making full range (from millivolts to + 700V) measurements of
floating signals in power electronic circuits.
Included with Probe
|Bandwidth||DC to 100 MHz (-3dB)|
|Input Impedance||4Mohm //7pF each side to ground|
- Differential Range*
-Common Mode Range*
-Absolute Max. Voltage*(Differential or Common Mode)
70Vrms and +/- 70V(DC + Peak AC @ 1/10
700Vrms and +/- 700V(DC + Peak AC) @ 1/100
700Vrms and +/- 700V(DC + Peak AC) @ 1/10 & 1/100
1000Vrms and +/-1000V(DC + Peak AC) @ 1/10 & 1/100
- Swing (into 50 kohm load
- Source Impedance
50 ohm (for using 1 Mohm input system oscilloscope)
|CMMR (typical)||-85dB @ 50Hz, -55dB @ 1MHz|
|Ambient Operating Temperature||-10 to 40 degree centigrade|
|Ambient Storage Temperature||-30 to 70 degree centigrade|
|Ambient Operating Humidity||Up to 85% RH|
|Ambient Storage Humidy||Up to 85% RH|
|Power Requirements**||-Standard-options 4 x AA cells or 9 VDC 120mA mains adapter (Both included)
-Optional- Power Leads Power Leads
|Length of BNC Cable||36"|
|Length of Input Leads||12"|
|Dimensions||8" x 3 1/4" x 1 1/2"|
*Voltage limit is the lesser of the DC + Peak AC and RMS values.**
a. The supplied voltage must be less than 12V and greater than 4.4V, otherwize the probe could be damagedor will not operate properly.
b. polarity is "+" inside and "V" outside. For wrong polarity, built-in circuit protects the probe, no danger ordamage will occur.
c. When the voltage of the cells become too low, the power indicator on the panel wiill flicker. Additional Accessories- Shown Below
This product hasn't received any reviews yet. Be the first to review this product!