Sorry but this item is currently unavailable.
Please check back at a later stage.
Differential Probe for High Voltage Power Measurement- Model 4241
The 4241 meets IEC61010-031 Category I Requirements and is ideally suited for measuring high-speed voltage surge in power electronics circuits.
Included with Probe
Model 4241 Specifications
|Bandwidth||DC to 70MHz (-3dB)|
|Input Impedance||10 M OHm/10pF each side to ground|
|-Differential Input Voltage||700Vrms and +/-700V (DC+Peak AC ) @ 1/100
5000Vrms and +/- 7000V (DC +Peak AC) @ 1/1000
|-Common Mode Voltage||2500Vrms and+/-7000V (DC+ Peak AC) @ 1/100 & 1/1000|
|-Absolute Max . Input||2500Vrms and +/-7000V (DC+ Peak AC) @ 1/100 & 1/1000 in Commom Mode
5000Vrms and +/-7000V (DC +Peak AC) @ 1/100 & 1/1000 in Differential Mode
-Source Impedance (typical)
+ 7V (into 50kohm load)
50 Ohm (for using 1 Mohm input system oscilloscope)
|CMRR (typical)||-80dB @ 50Hz, -60dB @ 20kHZ|
|Ambient Operating temperature||-10 to 40 degree centigrade|
|Ambient Storage temperature||-30 to 70 degree centigrade|
|Ambient Operating humidity||Up to 85% RH|
|Ambient Storage humidity||Up to 85% RH|
|Power Requirements*||Standard- 4 x AA cells or 9VDC adapter (Both Included)
Options- Power Leads
|Length of Input Leads||23"|
|Length of BNC Cables||36"|
|Dimensions||(LxWxH) 8" x 3 1/4" x 1 1/2|
* a. The supplied voltage must be less than 12V and greater than 4.4V, otherwise the probe could be damaged or can¡¦t be operated properly.
b. polarity is "+" inside and "¡V" outside. For wrong polarity, built-in circuit protects the probe, no danger or damage will occur.
c. When the voltage of the cells become too low, the power indicator on the panel will flicker. Additional Accessories- Shown Below
This product hasn't received any reviews yet. Be the first to review this product!